Skip Nav Destination
Article navigation
July 1973
This article was originally published in
Journal of Lubrication Technology
Discussions
Discussion: “Analysis of an Arched Outer-Race Ball Bearing Considering Centrifugal Forces” (Hamrock, B. J., and Anderson, W. J., 1973, ASME J. Lubr. Technol., 95, pp. 265–271)
J. V. Poplawski
J. V. Poplawski
Homer Research Laboratories, Bethlehem Steel Corporation, Bethlehem, Pa.
Search for other works by this author on:
J. V. Poplawski
Homer Research Laboratories, Bethlehem Steel Corporation, Bethlehem, Pa.
J. of Lubrication Tech. Jul 1973, 95(3): 275 (1 pages)
Published Online: July 1, 1973
Article history
Online:
October 18, 2010
Connected Content
This is a commentary to:
Dynamic Gas Temperature Measurements in a Gas Turbine Transition Duct Exit
This is a commentary to:
Film-Cooling Effectiveness in the Near-Slot Region
Citation
Poplawski, J. V. (July 1, 1973). "Discussion: “Analysis of an Arched Outer-Race Ball Bearing Considering Centrifugal Forces” (Hamrock, B. J., and Anderson, W. J., 1973, ASME J. Lubr. Technol., 95, pp. 265–271)." ASME. J. of Lubrication Tech. July 1973; 95(3): 275. https://doi.org/10.1115/1.3451800
Download citation file:
155
Views
Get Email Alerts
Cited By
Tribological Behavior of Annealed FeCoNiMn0.25Al0.25 High-Entropy Alloy
J. Tribol (November 2025)
Friction Reduction and Lubrication Performance of New Microemulsion Cutting Fluid for AISI 1045
J. Tribol (December 2025)
Related Articles
An Analysis of Misaligned Single-Row Angular-Contact Ball Bearing
J. Mech. Des (March,2004)
Ball Motion and Sliding Friction in a Four-Contact-Point Ball Bearing
J. Tribol (October,2007)
The Life of High-Speed Ball Bearings
Trans. ASME (July,1952)
Analysis of an Arched Outer-Race Ball Bearing Considering Centrifugal Forces
J. of Lubrication Tech (July,1973)
Related Proceedings Papers
Related Chapters
Runout
Geometric Dimensioning and Tolerancing Handbook: Applications, Analysis & Measurement
Runout
Geometric Dimensioning and Tolerancing: Applications, Analysis, Gauging and Measurement [per ASME Y14.5-2018]
Slurry Dewatering System with Planetary Rotation Chambers
Geotechnics of High Water Content Materials