A baseline theory is developed in this paper for the design of oil-lubricated centrally pivoted plane-pad thrust bearings. By focusing on the hydrodynamics generated by the viscosity-temperature effects of the lubricating oil, a mathematical model is derived with a single dimensionless parameter . The nominal value of is 0.1 for typical pad bearings in current industrial practice. The theory suggests two important design calculations for centrally pivoted plane-pad bearings: (1) The minimum oil film thickness in the bearing is about 0.65 of the film thickness determined using the classical isothermal lubrication theory with the pad pivoted at the maximum-load optimum location. Thus, by setting the film thickness to 1.54 times the design requirement, one may carry out design selections and calculations using the classical theory. (2) The friction in the bearing is about 1.7 times the value determined using the classical theory at the maximum-load optimum condition and with the film thickness equal to the design requirement. Thus, one may also use the classical theory to meaningfully calculate the friction and power loss in the centrally pivoted plane-pad bearing systems. The theory is developed based on fundamental lubrication science, order of magnitude analyses of the assumptions, and supporting evidence from numerical literature case studies. It would be a conservative baseline theory for the bearing design as other complicated and/or incidental mechanisms would help provide a design factor of safety.
Skip Nav Destination
Article navigation
October 2010
Research Papers
A Baseline Theory for the Design of Oil-Lubricated Centrally Pivoted Plane-Pad Thrust Bearings
L. Chang
L. Chang
Department of Mechanical and Nuclear Engineering,
Pennsylvania State University
, University Park, PA 16802
Search for other works by this author on:
L. Chang
Department of Mechanical and Nuclear Engineering,
Pennsylvania State University
, University Park, PA 16802J. Tribol. Oct 2010, 132(4): 041703 (6 pages)
Published Online: October 7, 2010
Article history
Received:
May 3, 2010
Revised:
July 15, 2010
Online:
October 7, 2010
Published:
October 7, 2010
Citation
Chang, L. (October 7, 2010). "A Baseline Theory for the Design of Oil-Lubricated Centrally Pivoted Plane-Pad Thrust Bearings." ASME. J. Tribol. October 2010; 132(4): 041703. https://doi.org/10.1115/1.4002219
Download citation file:
Get Email Alerts
Cited By
Static Characteristics of Hybrid Water-Lubricated Herringbone Groove Journal Bearing
J. Tribol (April 2025)
Related Articles
Tri-Axial Force Measurements on the Cylinder of a Motored SI Engine Operated on Lubricants of Differing Viscosity
J. Eng. Gas Turbines Power (September,2010)
Load Capacity and Durability of H-DLC Coated Hydrodynamic Thrust Bearings
J. Tribol (July,2011)
Modified Reynolds Equation for Non-Newtonian Fluid With Rheological Model in Frequency Domain
J. Tribol (October,2005)
Soft Elastohydrodynamic Analysis of Radial Lip Seals With Deterministic Microasperities on the Shaft
J. Tribol (October,2007)
Related Chapters
Hydrodynamic Lubrication
Design of Mechanical Bearings in Cardiac Assist Devices
Friction, Bearings, and Lubrication
Engineering Practice with Oilfield and Drilling Applications
Contact Laws
Contact in Structural Mechanics: A Weighted Residual Approach