The aim of this study is to design the shapes of the surfaces of sliders to meet the load demands specified by the designers. A direct problem solver is built to provide solutions for pressure distribution between the slider and the rotor for various geometric conditions and load demands. The direct problem solver is then incorporated with the conjugate gradient method so as to develop an inverse method for the slider surface shape design. The specified load demands considered in this study are categorized into two kinds: (1) specified pressure distribution within the fluid film and (2) specified resultant forces plus specified centers of load. Several cases at various bearing numbers are tested to demonstrate the validity of the inverse shape design approach. Results show that the surface shape of a slider can be designed efficiently to comply with the specified load demands considered in the present study by using the inverse method.
Shape Design for Surface of a Slider by Inverse Method
Contributed by the Tribology Division for publication in the ASME JOURNAL OF TRIBOLOGY. Manuscript received by the Tribology Division March 13, 2003 revised manuscript received September 18, 2003. Associate Editor: L. San Andre´s.
- Views Icon Views
- Share Icon Share
- Search Site
Cheng, C., and Chang, M. (June 28, 2004). "Shape Design for Surface of a Slider by Inverse Method ." ASME. J. Tribol. July 2004; 126(3): 519–526. https://doi.org/10.1115/1.1704627
Download citation file: