Abstract
Ultrasonic inspection of conductive samples can be performed using electromagnetic acoustic transducers (EMATs). These allow generation of guided waves, such as Lamb waves, in thin plates. Lamb waves are used for defect screening as they can travel long distances with relatively little attenuation. However, large wavelengths are used, which results in poor sensitivity to subwavelength sized defects. This work presents methods for using Lamb waves to detect smaller defects. Curved, geometrically focused EMATs were used to generate and detect Lamb waves in a 1 mm thick aluminum plate. The focal spot of these EMATs is investigated and the dependence of the focal spot dimensions and locations on the wavelength of the generation signal are presented. An array of geometrically focused detection EMATs was used to measure a square machined defect, simulating wall thinning. Perturbations in the pulse transmission in the region of the defect were detected, along with reflections, with each detector in the array sensitive to different defect features. B-scans and C-scans are presented utilizing these perturbations and reflections to locate, size, and image the machined defect. Analysis of data from the B-scan is shown to accurately size the defect width to within . Very good agreement is shown between the C-scan images and the known location and orientation of the defect. Data fusion techniques are presented to combine data sets from different receiver EMATs and increase the defect detection capability, accuracy, and precision, with the potential for full defect sizing demonstrated.