Machining complex three dimensional surfaces is a challenging task. This paper presents two methods of machining these surfaces on a 4 and 5 axis machine, using a toroidal shaped cutter. The methods propose to align the principal axis of curvature of the machining surface with that of the machined surface in order to increase the volume of material removed. The increase in material removal at a point reduces the scallop height. Thus, fewer passes are required to achieve the same surface finish.
Issue Section:
Machine Tools—Control
1.
Vickers
G. W.
Bedi
S.
Haw
R.
The Definition and Manufacture of Compound Curvature Surfaces Using G-Surf
,” Computers in Industry
, Vol. 6
, 1985
, pp. 173
–183
.2.
Vickers, G. W., and Bedi, S., “Generating Smooth Curved Surfaces from Sparse Irregular Data,” Computers in Mechanical Engineering, Jan. 1988, pp. 52–58.
3.
Vickers
G. W.
Qwan
K. W.
Ball-Mills Versus End-Mills for Curved Surface Machining.
” ASME JOURNAL OF ENGINEERING FOR INDUSTRY
, Vol. 111
, Feb. 1989
, pp. 22
–26
.4.
Be´zier, P., The Mathematical Basis of the UNISURF CAD System, Butterworth, London, 1986.
5.
Bartels, R., Beatty J., and Barsky, B., An Introduction to Splines for Use in Computer Graphics and Geometric Modelling, Morgan Kaufmann, 1987.
6.
Farin, G., Curves and Surfaces for CAGD 1992, Academic Press, Boston.
7.
Piegl
L.
On NURBS: A Survey
,” Computer Graphics and Applications
, Vol. 11
, No. 1
, 1990
, pp. 55
–71
.8.
Bedi
S.
Surface Design Using Functional Blending
,” Computer-Aided Design
, Vol. 24
, No. 9
, Sept. 1992
, pp. 505
–511
.9.
Beach, R. C., “An Introduction to the Curves and Surfaces of Computer Aided Design,” 1991, Van Nostrand Reinhold, New York.
10.
Klass, R., and Schramm, Peter, “Numerically-Controlled Milling of CAD Surface Data,” Geometric Modelling Methods and Application, Hagen, H., and Roller, D., eds. 1991, Springer-Verlag, Berlin.
11.
Loverton, T., Scoones, A., and Karima, M., “On The Use of Computer Based Simulation To Reduce Die Manufacturing Lead Times,” IBEC’93, Body Assembly and Manufacture, 1993, pp. 99–105.
12.
Rao
N. V.
Bedi
S.
Buchal
R.
Implementation of the Principal Axis Method for Machining Sculptured Surfaces
,” Int. J. of Advanced Manufacturing Technology
, 1996
, Vol. 11
, No. 4
, pp. 249
–257
.13.
Rao, N. V., Ismail, F., and Bedi, S., “Tool Path planning Using Principal Axis Method,” 1996, Accepted for publicaion in the Int. J. of Machine Tools and Manufacture.
This content is only available via PDF.
Copyright © 1997
by The American Society of Mechanical Engineers
You do not currently have access to this content.
