A method for estimating the maximum drawing force in the deep drawing of cylindrical cups with flat-nosed punch is developed. The criterion is obtained using the load maximum principle for localization of the plastic flow. The criterion is then applied in an attempt to develop a simple and practically applicable method for deep drawing force evaluation. Simple charts are presented to obtain the maximum drawing force as a function of the tooling geometry and anisotropy for steel, brass and stainless steel.
Issue Section:Papers on Production Engineering
Topics:Anisotropy, Brass (Metal), Deformation, Geometry, Stainless steel, Steel, Stress, Tooling
This content is only available via PDF.
Copyright © 1982