Solutions of the complete axisymmetric Navier–Stokes equations for steady, laminar vapor flow in circular heat pipes with various lengths of evaporator and condenser have been obtained by finite-difference methods. In addition, a new series solution for the slow-motion case was obtained that is valid for arbitrary distributions of evaporation and condensation and that confirms the numerical result in the limit of low Reynolds number. For uniform evaporation and condensation, the motion in the evaporator is found to be described adequately by similar solutions in both limits, and in the transition from low to high Re, the flow is completely determined by the evaporator Reynolds number. The evaporator is very weakly coupled to the condenser. The conditions in the condenser are decidedly more complex, and similar solutions are of value only for small Reynolds numbers and long tubes. Reverse flows occur for condenser Reynolds numbers greater than two and occupy a substantial fraction of the condenser length. Complete flow descriptions for symmetrical and asymmetrical heat pipes were obtained, and practical results for the calculation of pressure losses in low-speed heat-pipe vapor flows are given.
Skip Nav Destination
Article navigation
Research Papers
Vapor Flow in Cylindrical Heat Pipes
C. A. Bankston,
C. A. Bankston
University of California, Los Alamos Scientific Laboratory, Los Alamos, N. M.
Search for other works by this author on:
H. J. Smith
H. J. Smith
University of Michigan, Ann Arbor, Mich.
Search for other works by this author on:
C. A. Bankston
University of California, Los Alamos Scientific Laboratory, Los Alamos, N. M.
H. J. Smith
University of Michigan, Ann Arbor, Mich.
J. Heat Transfer. Aug 1973, 95(3): 371-376 (6 pages)
Published Online: August 1, 1973
Article history
Received:
September 22, 1972
Online:
August 11, 2010
Article
Article discussed|
View article
Connected Content
A commentary has been published:
Discussion: “Vapor Flow in Cylindrical Heat Pipes” (Bankston, C. A., and Smith, H. J., 1973, ASME J. Heat Transfer, 95, pp. 371–376)
Citation
Bankston, C. A., and Smith, H. J. (August 1, 1973). "Vapor Flow in Cylindrical Heat Pipes." ASME. J. Heat Transfer. August 1973; 95(3): 371–376. https://doi.org/10.1115/1.3450066
Download citation file:
Get Email Alerts
Cited By
Related Articles
Temperature Response of Heat Transport in a Micro Heat Pipe
J. Heat Transfer (May,1999)
Effects of Film Evaporation and Condensation on Oscillatory Flow and Heat Transfer in an Oscillating Heat Pipe
J. Heat Transfer (April,2011)
Effect of Internal Wick Structure on Liquid-Vapor Oscillatory Flow and Heat Transfer in an Oscillating Heat Pipe
J. Heat Transfer (December,2009)
Transport in Passive, High Thermal, Conductivity Heat Spreaders
J. Heat Transfer (August,2011)
Related Proceedings Papers
Related Chapters
Evaluation of Moisture Accumulation in Composite Roof Decks in High Humidity Environments such as Natatoriums in Cold Climates Using Hygrothermal Modeling
Roofing Research and Standards Development: 10th Volume
The Special Characteristics of Closed-Cycle Gas Turbines
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential