The present research is an experimental study for the enhancement of boiling heat transfer using microporous coatings. Two types of coatings are investigated: one that is bonded using epoxy and the other by soldering. Effects on pool boiling performance were investigated, of different metal particle sizes of the epoxy-based coating, on R-123 refrigerants, and on water. All boiling tests were performed with 1 cm × 1 cm test heaters in the horizontal, upward-facing orientation in saturated conditions at atmospheric pressure and under increasing heat flux. The surface enhanced by the epoxy-based microporous coatings significantly augmented both nucleate boiling heat transfer coefficients and critical heat flux (CHF) of R-123 relative to those of a plain surface. However, for water, with the same microporous coating, boiling performance did not improve as much, and thermal resistance of the epoxy component limited the maximum heat flux that could be applied. Therefore, for water, to seek improved performance, the solder-based microporous coating was applied. This thermally conductive microporous coating, TCMC, greatly enhanced the boiling performance of water relative to the plain surface, increasing the heat transfer coefficient up to ∼5.6 times, and doubling the CHF.
Microporous Coatings to Maximize Pool Boiling Heat Transfer of Saturated R-123 and Water
Contributed by the Heat Transfer Division of ASME for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received February 7, 2014; final manuscript received March 3, 2015; published online April 16, 2015. Assoc. Editor: Keith Hollingsworth.
- Views Icon Views
- Share Icon Share
- Search Site
Han Kim, J., Gurung, A., Amaya, M., Muk Kwark, S., and You, S. M. (August 1, 2015). "Microporous Coatings to Maximize Pool Boiling Heat Transfer of Saturated R-123 and Water." ASME. J. Heat Transfer. August 2015; 137(8): 081501. https://doi.org/10.1115/1.4030245
Download citation file: