1.
Bardon, J. P., 1972, “Introduction a` l’Etude des Re´sistances Thermiques de Contact,” Revue Ge´ne´rale de Thermique Fr, No. 125, pp. 429–447.
2.
Bardon, J. P., 1994, “Bases Physiques des Conditions de Contact Thermique Imparfait entre Milieux en Glissement Relatif,” Revue Ge´ne´rale de Thermique Fr, No. 386, pp. 86–91.
3.
Beck
J. V.
1979
, “Effects of Multiple Sources in the Contact Conductance Theory
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 101
, pp. 132
–136
.4.
Berry
G. A.
Barber
J. R.
1984
, “The Division of Frictional Heat—A Guide to the Nature of Sliding Contact
,” ASME Journal of Tribology
, Vol. 106
, pp. 405
–415
.5.
Cooper
M.
Mikic
B. B.
Yovanovich
M. M.
1969
, “Thermal Contact Conductance
,” Int. J. of Heat and Mass Transfer
, Vol. 12
, pp. 279
–300
.6.
Cretegny, J. F., 1985, “Etude The´orique et Expe´rimentale des Raideurs de Contact,” The`se de Doctorat de l’ISMCM, Saint-Ouen (93), France.
7.
Degiovanni, A., and Moyne, C., 1989, “Re´sistance Thermique de Contact en Re´gime Permanent. Influence de la Ge´ome´trie du Contact,” Revue Ge´ne´rale de Thermique Fr, No. 334, pp. 557–563.
8.
El-Sherbiny
M.
Newcomb
T. P.
1977
, “The Temperature Distribution Due to Frictional Heat Generated Between a Stationary Cylinder and a Rotating Cylinder
,” Wear
, Vol. 42
, pp. 23
–42
.9.
Fletcher
L. S.
1988
, “Recent Developments in Contact Conductance Heat Transfer
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 110
, pp. 1059
–1070
.10.
Floquet
A.
Play
D.
Godet
M.
1978
, “Contribution a` l’Etude Thermique du Frottement Sec dans les Paliers
,” J. de Me´canique Applique´e
, 2
, No. 4
, pp. 499
–539
.11.
Gecim
B.
Winer
W. O.
1984
, “Steady Temperature in a Rotating Cylinder Subject to Surface Heating and Convective Cooling
,” ASME Journal of Tribology
, Vol. 106
, pp. 120
–127
.12.
Kennedy
F. E.
1984
, “Thermal and Thermomechanical Effects in Dry Sliding
,” Wear
, Vol. 100
, pp. 453
–476
.13.
Kounas
P. S.
Dimarogonas
A. D.
Sandor
G. N.
1972
, “The Distribution of Friction Heat Between a Stationary Pin and Rotating Cylinder
,” Wear
, Vol. 19
, pp. 415
–424
.14.
Laraqi
N.
1992
, “Tempe´rature de Contact et Coefficient de Partage de Flux Ge´ne´re´ par Frottement Sec entre Deux Solides. Approche Nouvelle de la Ge´ne´ration de Flux
,” Int. J. of Heat and Mass Transfer
, Vol. 35
, No. 11
, pp. 3131
–3139
.15.
Laraqi
N.
1996
, “Phe´nome`ne de Constriction Thermique dans les Contacts Glissants
,” Int. J. of Heat and Mass Transfer
, Vol. 39
, No. 17
, pp. 3717
–3724
.16.
Ling, F. F., and Simkins, T. E., 1963, “Measurement of Pointwise Juncture Condition of Temperature at the Interface of Two Bodies in Sliding Contact,” J. Basic Engineering, pp. 481–487.
17.
Mazo, L., Cassagne, B., Badie-Levet, D., and Bardon, J. P., 1978, “Etude des Conditions de Liaison Thermique dans le Cas de Frottement Sec Me´tal-Plastique,” Revue Ge´ne´rale de Thermique Fr, No. 204, pp. 921–933.
18.
Negus
K. J.
Yovanovich
M. M.
Beck
J. V.
1989
, “On the Nondimensionalization of Constriction Resistance for Semi-Infinite Heat Flux Tubes
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. III
, pp. 804
–807
.19.
Play
D.
Godet
M.
1977
, “Design on High Performance Dry Bearing
,” Wear
, Vol. 41
, pp. 25
–44
.20.
Vullierme
J. J.
Lagarde
J. J.
Cordier
H.
1979
, “Etude de la Re´sistance de Contact Entre Deux Mate´riaux—Influence de la Vitesse de Glissement
,” Int. J. of Heat and Mass Transfer
, Vol. 22
, pp. 1209
–1219
.21.
Whitehouse, D. J., and Archard, J. F., 1970, “The Proprieties of Random Surfaces of Significance in Their Contact,” Proc. Roy. Soc., 316, A, pp. 97–121.
22.
Yovanovich, M. M., 1976, “General Expression for Circular Constriction Resistances for Arbitrary Flux Distribution,” AIAA. 13th Aerospace Sciences Meeting, Pasadena, California, pp. 381–396.
This content is only available via PDF.
Copyright © 1997
by The American Society of Mechanical Engineers
You do not currently have access to this content.
