Skip Nav Destination
Article navigation
Discussions
Discussion: “An Investigation of the Flow Characteristics and of Losses in Radial Nozzle Cascades” (Hashemi, S. G. R., Lemak, R. J., and Owczarek, J. A., 1984, ASME J. Eng. Gas Turbines Power, 106, pp. 502–509)
M. Kurosaka
M. Kurosaka
Department of Aerospace and Mechanical Engineering, The University of Tennessee Space Institute, Tullahoma, Tenn. 37388
Search for other works by this author on:
M. Kurosaka
Department of Aerospace and Mechanical Engineering, The University of Tennessee Space Institute, Tullahoma, Tenn. 37388
J. Eng. Gas Turbines Power. Apr 1984, 106(2): 510 (1 pages)
Published Online: April 1, 1984
Article history
Online:
October 15, 2009
Article
Article discussed|
View article
Connected Content
This is a commentary to:
An Investigation of the Flow Characteristics and of Losses in Radial Nozzle Cascades
Citation
Kurosaka, M. (April 1, 1984). "Discussion: “An Investigation of the Flow Characteristics and of Losses in Radial Nozzle Cascades” (Hashemi, S. G. R., Lemak, R. J., and Owczarek, J. A., 1984, ASME J. Eng. Gas Turbines Power, 106, pp. 502–509)." ASME. J. Eng. Gas Turbines Power. April 1984; 106(2): 510. https://doi.org/10.1115/1.3239598
Download citation file:
Get Email Alerts
Cited By
Study of Injector Geometry and Parcel Injection Location on Spray Simulation of the Engine Combustion Network Spray G Injector
J. Eng. Gas Turbines Power (July 2023)
Fully Coupled Analysis of Flutter Induced Limit Cycles: Frequency Versus Time Domain Methods
J. Eng. Gas Turbines Power (July 2023)
Impact of Ignition Assistant on Combustion of Cetane 30 and 35 Jet-Fuel Blends in a Compression-Ignition Engine at Moderate Load and Speed
J. Eng. Gas Turbines Power (July 2023)
Related Articles
Flame Ionization Sensor Integrated Into a Gas Turbine Fuel Nozzle
J. Eng. Gas Turbines Power (January,2005)
3D RANS Simulation of Turbulent Flow and Combustion in a 5 MW Reverse-Flow Type Gas Turbine Combustor
J. Eng. Gas Turbines Power (November,2010)
Key Parameters for the Performance of Impaction-Pin Nozzles Used in
Inlet Fogging of Gas Turbine Engines
J. Eng. Gas Turbines Power (April,2007)
Direct-Transfer Preswirl System: A One-Dimensional Modular Characterization of the Flow
J. Eng. Gas Turbines Power (April,2005)
Related Proceedings Papers
Related Chapters
A Simple Carburetor
Case Studies in Fluid Mechanics with Sensitivities to Governing Variables
Adding Surface While Minimizing Downtime
Heat Exchanger Engineering Techniques
Investigation on Cavitating Flow of a Novel High Pressure Nozzle with Grooved Needle
Proceedings of the 10th International Symposium on Cavitation (CAV2018)