The authors discuss in this paper the potential of a method for suppression from power plants based on microgas turbines. The method is based on the mild combustion concept but needs to be adapted to the actual operating parameters of the microturbine, thus resulting in an effective employment of the flue gas recirculation for diluting the oxygen in the inlet air. The results are first presented on a thermodynamic basis, and some cases are then analyzed with a computational fluid dynamics simulation. Both approaches suggest good perspectives for the nitric oxide control but also highlight some disadvantages in terms of increase in carbon species.
Issue Section:
Gas Turbines: Cycle Innovations
1.
Cameretti
, M. C.
, and Tuccillo
, R.
, 2004, “Comparing Different Solutions for the Micro-GasTurbine Combustor
,” ASME Paper No. GT 2004-GT-53286.2.
Bozza
, F.
, and Tuccillo
, R.
, 2004, “Transient Operation Analysis of a Cogenerating Micro-Gas Turbine
,” ASME Paper No. ESDA-2004-58079.3.
Bozza
, F.
, Cameretti
, M. C.
, and Tuccillo
, R.
, 2005, “Adapting the Micro-Gas Turbine Operation to Variable Thermal and Electrical Requirements
,” ASME J. Eng. Gas Turbines Power
0742-4795, 127
, pp. 514
–524
.4.
Cameretti
, M. C.
, and Tuccillo
, R.
, 2005, “A CFD Based Off-Design Study of Micro-Gas Turbines Combustors
,” ASME Paper No. GT-2005-68924.5.
Tuccillo
, R.
, and Cameretti
, M. C.
, 2005, “Combustion and Combustors for MGT Applications
,” VKI/LS on “Micro Gas Turbines,” RTO-MP-AVT-131.6.
Tuccillo
, R.
, 2005, “Performance and Transient Behaviour of MTG Based Energy Systems
,” VKI/LS on “Micro Gas Turbines,” RTO-MP-AVT-131.7.
Levy
, Y.
, Sherbaum
, V.
, and Erenburg
, V.
, 2005 “Fundamentals of Low-NOx Gas Turbine Adiabatic Combustor
,” ASME Paper No. GT2005-68321.8.
Camporeale
, S.
, Casalini
, F.
, and Saponaro
, A.
, 2003, “Mild Combustion in a Novel Ccgt Cycle With Partial Flue Gas Recirculation
,” ASME Paper No. GT2003-38743.9.
Vaz1
, C. D.
, Borges
, A. R. J.
, Van Buijtenen
, J.
, Spliethoff1
, H.
, 2004, “On the Stability Range of a Cylindrical Combustor for Operation in the Flox Regime
,” ASME Paper No. GT2004-53790.10.
Kalb
, R. J.
, and Sattelmayer
, T.
, 2004, “Lean Blowout Limit and NOx-Production of a Premixed Sub-ppm NOx Burner With Periodic Flue Gas Recirculation
,” ASME Paper No. GT2004-53410.11.
Croce
, G.
, Mori
, G.
, and Parente
, J.
, 2003, “Assessment of Traditional and Flamelets Models for Micro Turbine Combustion Chamber Optimisation
,” ASME Paper No. GT-2003-3838512.
Parente
, J.
, Mori
, G.
, Anisimov
, V.
, and Croce
, G.
, 2004, “Micro Gas Turbine Combustion Chamber Design, and CFD Analysis
,” ASME Paper No. GT2004-54247.13.
Bozza
, F.
, Cameretti
, M. C.
, and Tuccillo
, R.
, 2004, “The Employment of Hydrogenated Fuels From Natural Gas Reforming: Gas Turbine and Combustion Analysis
,” ASME J. Eng. Gas Turbines Power
0742-4795, 126
, pp. 489
–497
.14.
Ibrahim
, O.
, Zimmermann
, P.
, Hirsch
, C.
, Sattelmayer
, T.
, Gerhard
, B.
, and Steinbach
, C.
, 2004, “Microturbine Operating With Variable Heat Output
,” ASME Paper No. GT-2004–53011.15.
Mc Bride
, B. J.
, and Gordon
, S.
, 1994, “Computer Program for Calculation of Complex Equilibrium Composition and Applications
,” NASA RP 1311, Parts I and II.16.
Traverso
, A.
, Calzolari
, F.
, and Massardo
, A. F.
, 2003, “Transient Analysis and Control System for Advanced Cycles Based on Micro Gas Turbine Technology
,” ASME Paper No. GT-2003-38269.17.
Takase
, K.
, Furukawa
, H.
, and Nakano
, K.
, 2002, “A Preliminary Study of an Inter-Cooled and Recuperative Microgasturbine Below 300kW
,” ASME Paper No. GT-2002-30403.18.
Lagerström
, G.
, and Xie
, M.
, 2002, “High Performance & Cost Effective Recuperator for Micro-Gas Turbines
,” ASME Paper No. GT-2002-30402.19.
Proeschel
, R. A.
, 2002, “Proe 90™ Recuperator for Micro-Turbine Applications
,” ASME Paper No. GT-2002-30406.20.
Zel’dovich
, Y. B.
, Sadovnikov
, P. Y.
, and Frank-Kamenetskik
, D. A.
, 1947, Oxidation of Nitrogen in Combustion
, Academy of Science of SR
, Institute of Chemical Physics, Moscow-Leningrad
.21.
Amsden
, A. A.
, 1997, “KIVA-III v: Block Structured KIVA Program Engine With Vertical or Canted Valves
,” LA—Los Angeles 13313—MS, Los Alamos.22.
Magnussen
, B. F.
, and Hjertager
, B. H.
, 1977, “On Mathematical Modeling of Turbulent Combustion With Special Emphasis on Soot Formation
,” 16th Symposium on Combustion
, The Combustion Institute
, Pittsburgh.23.
Nicol
, G. D.
, Malte
, P. C.
, Hamer
, A. J
, Roby
, R. J.
, and Steele
, R. C.
, 1998, “A Five-Step Global Methane Oxidation—NO Formation Mechanism for Lean Premixed Gas Turbine Combustione
,” ASME Paper No. 98-GT-185.24.
Miller
, J. A.
, and Bowman
, C. T.
, 1989, “Mechanism and Modeling of Nitrogen Chemistry in Combustion
,” Prog. Energy Combust. Sci.
0360-1285, 15
, pp. 287
–338
.25.
Spadaccini
, L. J.
, and TeVelde
, L. J.
, 1982, “Autoignition Characteristics of Aircraft Type Fuels
,” Combust. Flame
0010-2180, 46
, 283
–300
.26.
Li
, S. C.
, and Williams
, F. A.
, 2000, “Reaction Mechanism for Methane Ignition
,” ASME Paper No. 2000-GT-145.27.
Roy
, C. J.
, Moran
, A. J.
, and Thomas
, G. O.
, 2001, “Autoignition Characteristics of Gaseous Fuels at Representative Gas Turbine Conditions
,” ASME Paper No. 2001-GT-0051.Copyright © 2007
by American Society of Mechanical Engineers
You do not currently have access to this content.