In a shear-force pump with multiple corotating disks, the pressure gain is obtained by utilizing the shear force produced on the surfaces of the rotating disks. Thus, it is expected to have advantages as a microfluid device compared to a conventional bladed compressor or pump, which suffers greatly from viscous loss. However, in previous studies, a shear-force pump could not achieve high efficiency in experiments, even though very good efficiencies were predicted in numerical and analytical studies on the flow field between corotating disks. Therefore, the objective of the present work was to investigate the internal flow dynamics and clarify the loss mechanisms in a complete shear-force pump device consisting of both rotor and stationary components. In order to achieve this goal, a numerical simulation using an independent rotor analysis was first performed on the internal flow field between two corotating disks to evaluate the isentropic efficiency and pressure coefficient that could be achieved. Then, an experimental test rig for a shear-force pump was designed and built, and an experiment was carried out to determine the performance of a complete pump device with the same corotating disk design as the independent rotor analysis. In addition, a numerical simulation was executed for the flow field of a pump system consisting of both rotor and stationary components based on the present test rig to investigate the flow field and loss factors of this device. The results of this independent rotor analysis showed that the corotating disks can achieve a fairly high efficiency at a low flow coefficient with a high dynamic pressure, and the flow direction is extremely close to the tangential direction at the disk outlet, which caused difficulties in the design of the diffuser and scroll. In the experimental test, the high total pressure loss in the parallel diffuser and scroll parts was observed. This was found to be the result of the significant friction loss caused by the long flow path due to strong recirculation in the diffuser and scroll volute, which was found in the simulation results for the internal flow in the whole pump system. In addition, a reverse flow appeared in the rotor part at a low flow coefficient, which significantly deteriorated the rotor performance. These conclusions provided some clues for improving the performance of a shear-force pump device in future work.

## References

1.
Epstein
,
A. H.
,
2004
, “
Millimeter Scale, Micro-Electro-Mechanical Systems Gas Turbine Engines
,”
ASME J. Eng. Gas. Turb. Power
,
126
(
2
), pp.
205
226
.10.1115/1.1739245
2.
Muller
,
R.
, and
Frechete
,
L.
,
2002
, “
Performance Analysis of Brayton and Rankine Cycle Micro Systems for Portable Power Generation
,” ASME IMECE2002-39638.
3.
Blanchard
,
D.
,
Ligrani
,
P.
, and
Bruce
,
G.
,
2005
, “
Single Disk and Double Disk Viscous Micro Pumps
,”
Sensors Actuators A
,
122
, pp.
145
158
.10.1016/j.sna.2005.03.072
4.
Miller
,
G. E.
,
Etter
,
B. D.
, and
Dorsi
,
J. M.
,
1990
, “
A Multiple Disk Centrifugal Pump as a Blood Flow Device
,”
IEEE Trans. Biomed. Eng.
,
37
, pp.
157
163
.10.1109/10.46255
5.
Sirakov
,
B. T.
,
Gong
,
Y.
,
Epstein
,
A. H.
, and
Tan
,
C. S.
,
2004
, “
Design and Characterization of Micro-Compressor Impellers
,” ASME Paper No. GT2004-53332.
6.
Deam
,
R. T.
,
Lemma
,
E.
,
Mace
,
B.
, and
Collins
,
R.
,
2008
, “
On Scaling Down Turbines to Millimeter Size
,”
ASME J. Eng. Gas. Turb. Power
,
130
(
5
), pp.
1
9
.10.1115/1.2938516
7.
Lemma
,
E.
,
Deam
,
R. T.
,
Tonicich
,
D.
, and
Collins
,
R.
,
2008
, “
Characterization of a Small Viscous Flow Turbine
,”
Experiment. Therm. Fluid Sci.
,
33
(
1
), pp.
96
105
.10.1016/j.expthermflusci.2008.07.009
8.
Hoya
,
G. P.
, and
Guha
,
A.
,
2009
, “
The Design of a Test-Rig and Study of the Performance and Efficiency of a Tesla Disc Turbine
,”
Proc. IMechE A J. Power Energ.
,
223
, pp.
451
465
.10.1243/09576509JPE664
9.
Laroche
,
E.
, and
Ribaud
,
Y.
,
1999
, “
An Analysis of the Internal Aerodynamic Losses Produced in the Laminar and Centrifugal Flow Between Two Parallel Co-rotating Disks
,”
Proc. 3rd European Conference on Turbomachinery-Fluid Dynamics and Thermodynamics
, IMechE Event Publications, London, Paper No. C557/001/99.
10.
Tesla
,
N.
,
1913
, “
Fluid Propulsion
,” U.S. Patent No. 1,061,142.
11.
Truman
,
C. R.
,
Rice
,
W.
, and
Jankowski
,
D. F.
,
1979
, “
Laminar Through Flow of a Fluid Containing Particles Between Corotating Disks
,”
ASME J. Fluids Eng.
,
101
(
1
), pp.
87
92
.10.1115/1.3448740
12.
Truman
,
C. R.
,
Rice
,
W.
, and
Jankowski
,
D. F.
1978
, “
Laminar Through Flow of Varying-Quality Stream Between Corotating Disks
,”
ASME J. Fluids Eng.
,
100
(
2
), pp.
194
200
.10.1115/1.3448629
13.
Hasinger
,
S. H.
,
Kehrt
,
L. G.
, and
Goksol
,
O. T.
,
1965
, “
Cavitation Tests With a High Efficiency Shear Force Pump
,”
Proc. ASME Symposium on Cavitation in Fluid Machinery
, Chicago, IL, pp.
132
147
.
14.
Medvitz
,
R. B.
,
Boger
,
D. A.
,
Izraelev
, V
.
,
Rosenberg
,
G.
, and
Paterson
,
E. G.
,
2011
, “
CFD Design and Analysis of a Passively Suspended Tesla Pump Left Ventricular Asis Device
,”
Artificial Organs
,
35
(
5
), pp.
522
533
.10.1111/j.1525-1594.2010.01087.x
15.
Breiter
,
M. C.
, and
Pohlhausen
,
K.
,
1962
, “
Laminar Flow Between Two Parallel Rotating Disks
,” Aeronautical Research Laboratories, Wright-Patterson Air Force Base, OH, Technical Report No. ARL 62-318.
16.
Boyd
,
K. E.
, and
Rice
,
W.
,
1968
, “
Laminar Inward Flow of an Incompressible Fluid Between Rotating Disks With Full Peripheral Admission
,”
ASME J. Appl. Mech.
,
90
(
2
), pp.
229
237
.10.1115/1.3601185
17.
Boyack
,
K. E.
, and
Rice
,
W.
,
1971
, “
Integral Method for Flow Between Corotating Disks
,”
ASME J. Basic Eng.
,
93
(
3
), pp.
350
354
.10.1115/1.3425252
18.
Crawford
,
M. E.
, and
Rice
,
W.
,
1974
, “
Calculated Design Data for the Multiple-Disk Pump Using Incompressible Fluid
,”
ASME J. Eng. Power
,
96
(
3
), pp.
274
282
.10.1115/1.3445806
19.
,
R. G.
, and
Rice
,
W.
,
1970
, “
Experimental Investigation of the Flow Between Corotating Disks
,”
ASME J. Appl. Mech.
,
92
(
3
), pp.
844
849
.10.1115/1.3408618
20.
Rice
,
W.
,
1963
, “
An Analytical and Experimental Investigation of Multiple Disk Pumps and Compressors
,”
ASME J. Eng. Power
,
85
(
3
),
pp, 191
199
.10.1115/1.3675253
21.
Hasinger
,
S. H.
, and
Kehrt
,
L. G.
,
1963
, “
Investigation of a Shear Force Pump
,”
ASME J. Eng. Power
,
85
, pp.
191
198
.10.1115/1.3675253
22.
Rice
,
W.
,
2003
, “
Tesla Turbomachinery
,”
Handbook of Turbomachinery
,
Logan
,
E.
, and
Ray
,
R.
,
Marcel Dekker
,
New York
, Chap. 14.
23.
Van Doormaal
,
J. P.
, and
Raithby
,
G. D.
,
1984
, “
Enhancement of the SIMPLE Method for Predicting Incompressible Fluid Flows
,”
Numer. Heat Transf. B
,
7
(
2
), pp.
147
163
.10.1080/10407798408546946
24.
Rhie
,
C. M.
, and
Chow
,
W. L.
,
1983
, “
A Numerical Study of Turbulent Flow Past an Isolated Airfoil With Trailing Edge
,”
AIAA J.
,
21
(
11
), pp.
1525
1552
.10.2514/3.8284