Issue Section:
Technical Briefs
1.
Bar-Meir, G., 1995a, “On Gas/Air Porosity in Pressure Die Casting,” PhD thesis, University of Minnesota.
2.
Bar-Meir
G.
1995
b, “Analysis of Mass Transfer Processes in the Pore Free Technique
,” ASME Journal of Engineering Materials and Technology
, Vol. 117
, pp. 215
–219
.3.
Bar-Meir
G.
Eckert
E.
Goldstein
R. J.
1996
, “Pressure Die Casting: A Model of Vacuum Pumping
,” ASME Journal of Engineering for Industry
, Vol. 118
, pp. 001
–007
.4.
Draper
A. B.
1967
, “Effect of Vent and Gate Areas on the Porosity of Die Casting
,” Transactions of American Foundrymen’s Society
, Vol. 75
, pp. 727
–734
.5.
Hu, J., Ramalingam, S., Meyerson, G., Eckert, E., and Goldstein, R. J., 1992, “Experiment and Computer Modeling of the Flows in Pressure Die Casting Casings,” ASME/CIE Design, San Francisco, CA.
6.
Lindsey, D., and Wallace, J. F., 1972, “Effect of Vent Size and Design, Lubrication Practice, Metal Degassing, Die Texturing and Filling of Shot Sleeve on Die Casting Soundness,” Transactions 7th SDCE International Die Casting Congress, Chicago, paper 10372.
7.
Sachs, B., 1952, “An Analytical Study of the Die Casting Process,” PhD thesis, Columbia University.
8.
Shapiro, A. H., 1953, The Dynamics and Thermodynamics of Compressible Fluid Flow, Vol. I, Wiley, New York.
9.
Veinik, A. I., 1962, Theory of Special Casting Method, ASME, New York.
This content is only available via PDF.
Copyright © 1997
by The American Society of Mechanical Engineers
You do not currently have access to this content.
