This paper reports the findings of an investigation into the molecular structures and properties of three asphaltene samples, namely, an asphaltene sample extracted from Buton Oil Sand (Indonesia), and two asphaltene samples extracted from vacuum residues from Liaohe Refinery (China) and Vene Refinery (Venezuela), respectively. The average molecular structural parameters, including the average polycyclic aromatic hydrocarbon (PAH) size, average side chain length, and average molecular weight (AMW), of the three asphaltene samples were estimated using data from nuclear magnetic resonance (NMR) in combination with distortionless enhancement by polarization transfer (DEPT), and then compared against each other. The molecular weight distributions (MWDs) of the three asphaltene samples were measured using a matrix-assisted laser desorption/ionization time-of-flight (MALDI-TOF) mass spectrometry. The results indicated that the island molecular architecture predominated in all three asphaltenes and the average polycyclic aromatic hydrocarbon size was found to be six rings. The average molecular weight of the Buton asphaltene sample was found to be ca. 800 Da while those of the two petroleum asphaltene samples were approximately 600 Da. In comparison, the Buton asphaltene sample contained a much higher level of oxygen and sulfur, but a lower aromaticity than those of the two petroleum asphaltene samples. The use of liquid NMR in combination with DEPT was shown to provide an effective method for characterization and estimation of the molecular structures of asphaltenes, supported by MALDI-TOF mass spectra.
Skip Nav Destination
Article navigation
Research-Article
A Preliminary Investigation Into the Characterization of Asphaltenes Extracted From an Oil Sand and Two Vacuum Residues From Petroleum Refining Using Nuclear Magnetic Resonance, DEPT, and MALDI-TOF
Ce Zheng,
Ce Zheng
Centre for Energy (M473),
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
Search for other works by this author on:
Mingming Zhu,
Mingming Zhu
Centre for Energy (M473),
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
e-mail: mingming.zhu@uwa.edu.au
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
e-mail: mingming.zhu@uwa.edu.au
Search for other works by this author on:
Wenxu Zhou,
Wenxu Zhou
Centre for Energy (M473),
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
Search for other works by this author on:
Dongke Zhang
Dongke Zhang
Centre for Energy (M473),
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
Search for other works by this author on:
Ce Zheng
Centre for Energy (M473),
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
Mingming Zhu
Centre for Energy (M473),
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
e-mail: mingming.zhu@uwa.edu.au
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
e-mail: mingming.zhu@uwa.edu.au
Wenxu Zhou
Centre for Energy (M473),
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
Dongke Zhang
Centre for Energy (M473),
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
The University of Western Australia,
35 Stirling Highway,
Crawley, WA 6009, Australia
1Corresponding author.
Contributed by the Petroleum Division of ASME for publication in the JOURNAL OF ENERGY RESOURCES TECHNOLOGY. Manuscript received January 4, 2016; final manuscript received December 21, 2016; published online February 6, 2017. Assoc. Editor: Daoyong (Tony) Yang.
J. Energy Resour. Technol. May 2017, 139(3): 032905 (9 pages)
Published Online: February 6, 2017
Article history
Received:
January 4, 2016
Revised:
December 21, 2016
Citation
Zheng, C., Zhu, M., Zhou, W., and Zhang, D. (February 6, 2017). "A Preliminary Investigation Into the Characterization of Asphaltenes Extracted From an Oil Sand and Two Vacuum Residues From Petroleum Refining Using Nuclear Magnetic Resonance, DEPT, and MALDI-TOF." ASME. J. Energy Resour. Technol. May 2017; 139(3): 032905. https://doi.org/10.1115/1.4035746
Download citation file:
Get Email Alerts
Cited By
Primary investigation of Ilmenite Dosage Effect on the Water-Based Drilling Fluid Properties
J. Energy Resour. Technol
Related Articles
Dynamic Analysis of Downhole Tool String in Uplift and Downshoot Motion
J. Energy Resour. Technol (January,0001)
Prediction and analysis of sustained annular pressure of gas wells considering the influence of production system and liquid thermodynamic properties
J. Energy Resour. Technol (January,0001)
A NOVEL TRAJECTORY-BASED MECHANISTIC MODEL FOR PREDICTING SOLID PARTICLE EROSION IN ELBOWS
J. Energy Resour. Technol (January,0001)
A Tight-Binding for Calculating the Raman Spectra and the Hartree–Fock Method Treatment for C 13 NMR Spectra of Fullerenes C 60 Br 6
J. Nanotechnol. Eng. Med (February,2011)
Related Proceedings Papers
Related Chapters
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
The CGM File Parsing Based CARNAC.NET
International Conference on Future Computer and Communication, 3rd (ICFCC 2011)
Characterizing the Resource
Geothermal Heat Pump and Heat Engine Systems: Theory and Practice