Dense and microcrack free yttria-stabilized zirconia (YSZ) was deposited onto porous NiO-YSZ anode tubes by dip coating without any vacuum assistance. The anode tubes were prepared by slip casting. Open circuit voltage of 1.05 V was obtained at , implying that the gas tightness of dip coating YSZ membranes is eligible for solid oxide fuel cell application. A fuel cell of -YSZ provides maximum power densities of , , , and at , , , and , respectively. The impedance data indicate that the resistivity of the YSZ electrolyte membrane is about at . At the same temperature, the electrode polarization resistance accounts for 74.8% of the cell’s total resistance under maximum power density condition.
Issue Section:
Research Papers
1.
Minh
, N. Q.
, 1993, “Ceramic Fuel Cell
,” J. Am. Ceram. Soc.
0002-7820, 76
, pp. 563
–588
.2.
Singhal
, S. C.
, 2002, “Solid Oxide Fuel Cells for Stationary, Mobile, and Military Applications
,” Solid State Ionics
0167-2738, 152–153
, pp. 405
–410
.3.
Mertens
, J.
, Haanappel
, V. A. C.
, Tropartz
, C.
, Herzhof
, W.
, and Buchkremer
, H. P.
, 2006, “The Electrochemical Performance of Anode-Supported SOFCs With LSM-Type Cathodes Produced by Alternative Processing Routes
,” ASME J. Fuel Cell Sci. Technol.
1550-624X, 3
, pp. 125
–130
.4.
Jiang
, S. P.
, Chen
, X. J.
, Chan
, S. H.
, Kwok
, J. T.
, and Khor
, K. A.
, 2006, “La0.75Sr0.25Cr0.5Mn0.5O3/YSZ Composite Anodes for Methane Oxidation Reaction in Solid Oxide Fuel Cells
,” Solid State Ionics
0167-2738, 177
, pp. 149
–157
.5.
Xu
, X. Y.
, Xia
, C. R.
, Huang
, S. G.
, and Peng
, D. K.
, 2005, “YSZ Thin Films Deposited by Spin-Coating for IT-SOFCs
,” Ceram. Int.
0272-8842, 31
(8
), pp. 1061
–1064
.6.
de Souza
, S.
, Visco
, S. J.
, and Jonghe
, L. C.
, 1997, “Thin-Film Solid Oxide Fuel Cell With High Performance at Low Temperature
,” Solid State Ionics
0167-2738, 98
, pp. 57
–61
.7.
Jia
, L.
, Lu
, Z.
, Huang
, X. Q.
, Liu
, Z. G.
, Zhi
, Z.
, Sha
, X. Q.
, Li
, G. Q.
, and Su
, W. H.
, 2007, “Preparation of YSZ Film by Gravity-Electrophoretic Deposition and Its Application in SOFC
,” Ceram. Int.
0272-8842, 33
(4
), pp. 631
–635
.8.
Basu
, R. N.
, Blass
, G.
, Buchkremer
, H. P.
, Stover
, D.
, Tietz
, F.
, Wessel
, E.
, and Vinke
, I. C.
, 2005, “Simplified Processing of Anode-Supported Thin Film Planar Solid Oxide Fuel Cells
,” J. Eur. Ceram. Soc.
0955-2219, 25
, pp. 463
–471
.9.
Cai
, Z.
, Lan
, T. N.
, Wang
, S.
, and Dokiya
, M.
, 2002, “Supported Zr(Sc)O2 SOFCs for Reduced Temperature Prepared by Slurry Coating and Co-Firing
,” Solid State Ionics
0167-2738, 152–153
, pp. 583
–590
.10.
Chen
, K. F.
, Lu
, Z.
, Ai
, N.
, Huang
, X. Q.
, Zhang
, Y. H.
, Xin
, X. S.
, Zhu
, R. B.
, and Su
, W. H.
, 2006, “Development of Yttria-Stabilized Zirconia Thin Films via Slurry Spinning Coating for Intermediate-to-Low Temperature Solid Oxide Fuel Cells
,” J. Power Sources
0378-7753, 160
, pp. 436
–438
.11.
Sammes
, N. M.
, Du
, Y.
, and Bove
, R.
, 2005, “Design and Fabrication of a 100 W Anode Supported Micro-Tubular SOFC Stack
,” J. Power Sources
0378-7753, 145
, pp. 428
–434
.12.
Kim
, J. W.
, Virkar
, A. V.
, Fung
, K. Z.
, Mehta
, K.
, and Singhal
, S. C.
, 1999, “Polarization Effects in Intermediate Temperature, Anode-Supported Solid Oxide Fuel Cells
,” J. Electrochem. Soc.
0013-4651, 146
, pp. 69
–78
.13.
Chen
, K. F.
, Lu
, Z.
, Chen
, X. J.
, Ai
, N.
, Huang
, X. Q.
, Du
, X. B.
, and Su
, W. H.
, 2007, “Development of LSM-Based Cathodes for Solid Oxide Fuel Cells Based on YSZ Films
,” J. Power Sources
0378-7753, 172
, pp. 742
–748
.14.
Zhao
, F.
, and Virkar
, A. V.
, 2005, “Dependence of Polarization in Anode-Supported Solid Oxide Fuel Cells on Various Cell Parameters
,” J. Power Sources
0378-7753, 141
, pp. 79
–95
.15.
Suzuki
, T.
, Yamaguchi
, T.
, Fujishiro
, Y.
, and Awano
, M.
, 2006, “Fabrication and Characterization of Micro Tubular SOFCs for Operation in the Intermediate Temperature
,” J. Power Sources
0378-7753, 160
, pp. 73
–77
.16.
Sammes
, N. M.
, and Du
, Y. H.
, 2007, “Fabrication and Characterization of Tubular Solid Oxide Fuel Cells
,” Int. J. Appl. Ceram. Technol.
1546-542X, 4
(2
), pp. 89
–102
.17.
Suzuki
, T.
, Yamaguchi
, T.
, Fujishiro
, Y.
, and Awano
, M.
, 2006, “Improvement of SOFC Performance Using a Microtubular Anode-Supported SOFC
,” J. Electrochem. Soc.
0013-4651, 153
(5
), pp. A925
–A928
.18.
Sui
, J.
, and Liu
, J.
, 2007, “An Electrolyte-Supported SOFC Stack Fabricated by Slip Casting Technique
,” ECS Trans.
1938-5862, 7
(1
), pp. 633
–637
.19.
Zhang
, Y. H.
, Huang
, X. Q.
, Lu
, Z.
, Ge
, X. D.
, Xu
, J. H.
, Xin
, X. S.
, Sha
, X. Q.
, and Su
, W. H.
, 2006, “Effect of Starting Powder on Screen-Printed YSZ Films Used as Electrolyte in SOFCs
,” Solid State Ionics
0167-2738, 177
, pp. 281
–287
.20.
Cheng
, J. G.
, Wang
, S. R.
, Fang
, X. H.
, Liu
, X. Q.
, and Meng
, G. Y.
, 2002, “On the Green Density, Sintering Behavior and Electrical Property of Tape Cast Ce0.9Gd0.1O1.95 Electrolyte Films
,” Mater. Res. Bull.
0025-5408, 37
, pp. 2437
–2446
.21.
Liu
, J.
, and Barnett
, S. A.
, 2002, “Thin Yttrium-Stabilized Zirconia Electrolyte Solid Oxide Fuel Cells by Centrifugal Casting
,” J. Am. Ceram. Soc.
0002-7820, 85
, pp. 3096
–3098
.22.
Xin
, X. S.
, Lu
, Z.
, Huang
, X. Q.
, Sha
, X. Q.
, Zhang
, Y. H.
, and Su
, W. H.
, 2006, “Anode-Supported Solid Oxide Fuel Cell Based on Dense Electrolyte Membrane Fabricated by Filter-Coating
,” J. Power Sources
0378-7753, 159
, pp. 1158
–1161
.23.
Zhang
, Y. L.
, Gao
, J. F.
, Meng
, G. Y.
, and Liu
, X. Q.
, 2004, “Production of Dense Yttria-Stabilized Zirconia Thin Films by Dip-Coating for IT-SOFC Application
,” J. Appl. Electrochem.
0021-891X, 34
, pp. 637
–641
.24.
Von Dollen
, P. V.
, and Barnett
, S.
, 2005, “A Study of Screen Printed Yttria-Stabilized Zirconia Layers for Solid Oxide Fuel Cells
,” J. Am. Ceram. Soc.
0002-7820, 88
(12
), pp. 3361
–3368
.25.
Badwal
, S. P. S.
, 1992, “Zirconia-Based Solid Electrolytes—Microstructure, Stability and Ionic Conductivity
,” Solid State Ionics
0167-2738, 52
(1–3
), pp. 23
–32
.26.
Leng
, Y. J.
, Chan
, S. H.
, Khor
, K. A.
, and Jiang
, S. P.
, 2004, “Performance Evaluation of Anode-Supported Solid Oxide Fuel Cells With Thin Film YSZ Electrolyte
,” Int. J. Hydrogen Energy
0360-3199, 29
, pp. 1025
–1033
.Copyright © 2010
by American Society of Mechanical Engineers
You do not currently have access to this content.