The longitudinal platoon control problem is considered under a leader and predecessor following scheme with a novel velocity-dependent spacing policy. With this spacing policy, the steady-state intervehicle distances increase with increasing cruise velocity and more so for vehicles that are closer to the leader. Since significant changes might be encountered in intervehicle distances during the travel due to the variations in the velocity of the leader, the problem is studied together with a more accurate modeling of aerodynamic effects within a platoon formation. Based on a standard feedback linearization approach, a dynamic output feedback synthesis problem is formulated with two performance objectives. One of the performance objectives is linked to the string stability of the platoon formation, while the other can be shaped in a way to maintain small spacing errors without aggressive vehicle maneuvers. A synthesis procedure is then outlined based on linear matrix inequality optimization (LMI). The new control scheme is investigated for a three-vehicle platoon by using an advanced aerodynamic model developed based on extensive fluid dynamic simulations. It is observed in this investigation that a desirable platoon operation can be achieved even with a simple aerodynamic model, provided that the controller is designed in a way to ensure good disturbance attenuation. Nevertheless, an accurate modeling of aerodynamic disturbances might be needed especially for the first vehicle after the leader when the cruising velocity varies over a wide range.
Skip Nav Destination
Article navigation
April 2018
Research-Article
Platoon Control Under a Novel Leader and Predecessor Following Scheme With the Use of an Advanced Aerodynamic Model
Hakan Köroğlu,
Hakan Köroğlu
Department of Signals and Systems,
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: hakankoroglu@yahoo.com
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: hakankoroglu@yahoo.com
Search for other works by this author on:
Maryam Mirzaei,
Maryam Mirzaei
Department of Applied Mechanics,
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: maryam.mirzaei@chalmers.se
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: maryam.mirzaei@chalmers.se
Search for other works by this author on:
Paolo Falcone,
Paolo Falcone
Department of Signals and Systems,
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: paolo.falcone@chalmers.se
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: paolo.falcone@chalmers.se
Search for other works by this author on:
Siniša Krajnović
Siniša Krajnović
Department of Applied Mechanics,
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: sinisa@chalmers.se
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: sinisa@chalmers.se
Search for other works by this author on:
Hakan Köroğlu
Department of Signals and Systems,
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: hakankoroglu@yahoo.com
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: hakankoroglu@yahoo.com
Maryam Mirzaei
Department of Applied Mechanics,
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: maryam.mirzaei@chalmers.se
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: maryam.mirzaei@chalmers.se
Paolo Falcone
Department of Signals and Systems,
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: paolo.falcone@chalmers.se
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: paolo.falcone@chalmers.se
Siniša Krajnović
Department of Applied Mechanics,
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: sinisa@chalmers.se
Chalmers University of Technology,
Gothenburg 41296, Sweden
e-mail: sinisa@chalmers.se
1Corresponding author.
2Present address: Ericsson AB, Stockholm 16480, Sweden.
Contributed by the Dynamic Systems Division of ASME for publication in the JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL. Manuscript received January 4, 2017; final manuscript received August 11, 2017; published online November 10, 2017. Assoc. Editor: Beshah Ayalew.
J. Dyn. Sys., Meas., Control. Apr 2018, 140(4): 041006 (13 pages)
Published Online: November 10, 2017
Article history
Received:
January 4, 2017
Revised:
August 11, 2017
Citation
Köroğlu, H., Mirzaei, M., Falcone, P., and Krajnović, S. (November 10, 2017). "Platoon Control Under a Novel Leader and Predecessor Following Scheme With the Use of an Advanced Aerodynamic Model." ASME. J. Dyn. Sys., Meas., Control. April 2018; 140(4): 041006. https://doi.org/10.1115/1.4037655
Download citation file:
Get Email Alerts
Cited By
Control of Autonomous Vehicles via Multi-Stage Linear Feedback Design
J. Dyn. Sys., Meas., Control
Co-Optimization of Design and Control of Energy Efficient Hybrid Electric Vehicles Using Coordination Schemes
J. Dyn. Sys., Meas., Control
Computationally Efficient Hierarchical Mpc via Koopman Operator
J. Dyn. Sys., Meas., Control
Balancing a Stick with Eyes Shut: Inverted Pendulum On a Cart Without Angle Measurement
J. Dyn. Sys., Meas., Control
Related Articles
Handling Delays in Yaw Rate Control of Electric Vehicles Using Model Predictive Control With Experimental Verification
J. Dyn. Sys., Meas., Control (December,2017)
Gain Scheduling-Inspired Boundary Control for Nonlinear Partial Differential Equations
J. Dyn. Sys., Meas., Control (September,2011)
Integrated Vehicle Dynamics Control Via Torque Vectoring Differential and Electronic Stability Control to Improve Vehicle Handling and Stability Performance
J. Dyn. Sys., Meas., Control (July,2018)
Fractional-Order Nonlinear Disturbance Observer Based Control of Fractional-Order Systems
J. Comput. Nonlinear Dynam (July,2018)
Related Proceedings Papers
Related Chapters
Norms of Feedback Systems
Robust Control: Youla Parameterization Approach
A Novel Approach for LFC and AVR of an Autonomous Power Generating System
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)
Regression Target – Objective Function
Nonlinear Regression Modeling for Engineering Applications: Modeling, Model Validation, and Enabling Design of Experiments