Chatter occurring at more than 10,000 Hz frequency was found in fine boring operation, and causing reduced tool life. To identify the mechanism for the onset of high frequency chatter, cutting tests and structural dynamics examination of the boring tool have been performed. Experimental study has revealed that the regenerative effect, the penetration effect, and the looping of the tool tip are three relevant characteristics in the onset of the chatter. Those findings are included in a new chatter model of which validity is evaluated by computational analysis of energy supplied and dissipated in the vibrating system.
A New Mechanism Explaining High Frequency Chatter Vibration Involving Tool Tip Looping in Fine Boring
Contributed by the Dynamic Systems and Control Division for publication in the JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL. Manuscript received by the Dynamic Systems and Control Division February 25, 2000. Associate Editor: J. F. Tu.
Edhi, E., and Hoshi, T. (February 25, 2000). "A New Mechanism Explaining High Frequency Chatter Vibration Involving Tool Tip Looping in Fine Boring ." ASME. J. Dyn. Sys., Meas., Control. September 2001; 123(3): 370–376. https://doi.org/10.1115/1.1387017
Download citation file: