Modern steam turbines must increasingly be designed for flexible operation. However an increasing amount of cold starts and load changes have a massive impact on fatigue resistance of the material. So the monitoring of thermal parameters of the casing is significant for checking thermally induced stresses and furthermore lifetime calculation. Additionally the measurement data is helpful for CFD validation reasons.

This paper presents a new proprietary developed sensor setup and measurement results. The sensors are flush mounted into a steam turbine at different axial and circumferential locations in the recirculation area between the intermediate and the lower pressure turbine. Hence it is possible to detect temperatures, temperature gradients and heat flux in the part of the wall near the fluid. Moreover the field of temperature within the sensor can be modulated by powering an installed heater. So the adiabatic wall temperature can be identified. For measuring the temperature gradient, seven equidistant spaced thermocouples were used in difference circuit. Therefore two different types of thermocouples were applied. Both types have better transfer characteristics compared to a thermocouple of type K. High amplification enables monitoring of small differences in temperature. The temperature measures an integrated resistor thermometer.

The sensors are applied on a real 12 MW industrial steam turbine with maximal live steam parameters of 400 °C and 30 bar. The measurements show various operation points and load changes.

This content is only available via PDF.
You do not currently have access to this content.